Customer Specific Special Order Set

I’ve attached 3 drawings for a set of 4 pistons. They are identical in many respects to a set you made for me in July 2013. The differences are in the pin height, now 22.1mm, the crown volume, now 9.5cc and the bore size, now 84.05mm. The rod small end thickness is 5.0mm

Could you make these with your asymmetric forgings, piston guided rods - small end width is 25.0mm - coatings on crown and skirt, 2 rings,  gas ported top groove with gapless ring, round wire locks, 2RH, 2LH.