Starion and Conquest Specials: ( Click to go to Main Starion / Conquest Page )
Pauter Forder 4340 Connecting Rods with ARP200 Bolts Installed.
Pauter 4340 Forged Rods for G54B
|
High Flow "B" pipe without cat...OFF ROAD USE ONLY !!!!!!!!
Click links for Pictures and more info |
|
|
Note that these pipes are Oversize and and carry a high shipping charge depending on your Zip Code...$59-$89 is average freight cost !
|
|
|
High Flow "B" pipe with 2.5" High Flow Cat. Smog Legal
Click links for Pictures and more info |
|
|
2.5" Mandrel Bent Downpipe with 1 wire 02 sensor
|
|
|
2.5" High Flow Weld In Catalytic Converter
|
|
|
HKS Cat Back Exhaust system. This goes from the end of our B-Pipe to the rear of the car.
|
|
|
TEP Exclusive METAL SHIM Head Gaskets !
Top and Bottom layer of steel shim with composite center layer. No leaks..Much stronger than any Copper head gasket....For use only with head studs at 85 ft. lbs torque.... |
|
|
Starion-Conquest T3/T4 Conversion Kit:
New T3/T4 Hybid Turbo, Cast Exhaust Manifold, Downpipe with 02 sensor Port, High Flow Inlet Pipe from Turbo to Mass Air Sensor, 3 Wire 02 Sensor |
Front and Rear Strut Brace Package
Rear Brace with Battery Re-Location kit
Rear Single Tube Brace Only
Stainless Steel Intake and Exahust Valve Set (8)
Street prepared heads
+ Add $99.00 for ARP Head Studs
+ Add $90.00 for Stainless Steel Valves
Super Special Performance Cylinder Head deal:
Street prepped head with Stainless Steel Valve, Street Ported,Performance Cam, H/D Valve springs, ARP Head Studs,Head gasket set with Metal Head Gasket
JE Forged 8.0:1 .040 over pistons with JE Ring Set
JE Forged 8.0:1 .040 over pistons with Total-Seal Gapless Ring Set
JE Forged Piston set in Any OTHER Bore Size or Compression Ratio with Total-Seal Gapless Rings
JE Forged Piston set in Any OTHER Bore Size or Compression Ratio withJE ProSeal Rings
Head Gasket set with Heavy Duty Head Gasket
Head Gasket set with TEP METAL Head Gasket
Bosch 350HP Fuel Pump
OVC Pipe with Large TurboXS Type-H Blow-Off Valve
3 piece Pluming kit with OVC Pipe with Large TurboXS Type-H Blow-Off Valve and 2
piece plumbing kit $450.00
Balance Shaft Eliminator kit with timing kit $150
Performance street clutch 225mm or 240mm $299
Tune Up Kit..NGK Plug Wires, NGK plugs, Cap and Rotor $79
Tune Up Kit #2..Accel 8mm Plug Wires, NGK plugs, Cap and Rotor $89
Bosch Red Coil: $59.00 In Stock...
|
Street Engine Rebuild Kit:
New Non-Jet valve bare head , 8 new stock valves, Heavy Duty valve Spring set, Performance camshaft, .040 Hypereutectic Piston set with Hastings rings, Balance shaft eliminator kit with timing components, Rod and Main bearings, Full gasket set, New Oil pump, New Head Bolts |
Note: These are Rebuild kits ONLY. Not complete or rebuilt engines...
|
Performance Street engine rebuild kit:
New Non-Jet valve bare head , 8 new SS valves, Heavy Duty valve Spring set, Performance camshaft, .040 JE Forged Pistons with Total-Seal Gapless rings, Balance shaft eliminator kit with timing components, Rod and Main bearings, Full gasket set with TEP Steel Shim Head Gasket, ARP Head Studs and Rod Bolts, New High Volume Oil pump |
| 240Z-280ZX Triple DCOE (40mm or 45mm Your Choice..) Kit (3) NEW Weber DCOE carbs with proper baseline jetting and Air Horns, Intake Manifold and and Complete Linkage kit, Anti-Vibration Mounts, and Manifold to head gasket... + For RamFlow Air Filters Add $139 + For Correct Electric Fuel Pump (Low pressure High Volume NO REGULATOR REQUIRED ) add $92 |
| 510 or 4 Cylinder L engine Dual DCOE (40mm or 45mm Your Choice..) Kit (2) NEW Weber DCOE carbs with proper baseline jetting and Air Horns, Intake Manifold and Linkage , Anti-Vibration Mounts, and Manifold to head gasket... + For Cable Linkage upgrade Add $75 + For RamFlow Air Filters Add $95 + For Correct Electric Fuel Pump (Low pressure High Volume NO REGULATOR REQUIRED ) add $89 |
Z Car and 510 Headers:
6 into 2 into 1 design with collector and Manifold Gasket
510 Shorty Header for use with L20 or other tall blocks with collector and manifold gasket.
|
Z Car Turbo and High Compression N/A Performance Engine Rebuild Package: |
| 4 Cylinder "L" engine (L16-L20B and NapsZ) Turbo and High Compression N/A Performance Engine Rebuild Package: Exactly the same as the 6 cylinder set above but with a composite head gasket instead of a Metal gasket. Add $835 for Forged 4340 Con Rods with ARP2000 bolts installed |
Turbo Oil Pump with Dual Relief Springs
Complete Timing Gear Set...Chain, Guides, Tensioner, Crank and Cam gears
JE Forged pistons for Z car. (L24-L28 or VG30) Set of 6 with wrist pins and JE rings
JE Forged pistons for 4 cylinder L16-L20B, KA24, SR20 Set of 4 with wrist pins and JE rings
Urethane Strut Rod Bushings
Lowering coils:Set of 4
240Z-280Z
280ZX
Street Camber plates 240Z-280Z pair front or rear
Street Camber plates 510
510 Urethane bushing set
Front control arm, Rear control arm, Strut rods, Idler arm, Rear subframe, Mustache bar bushings.
240Z-280Z Urethane bushing set
Front control arm, Rear control arm, Strut rods, Steering rack, Mustache bar bushings.
510 Street suspension kit: $1245
Urethane bushing kit, Front 1” sway bar with urethane bushings, Rear ¾” bar with urethane bushings, Front Coil-Over kit for use on your strut housings ( Must be cut and welded ), Rear Coil Springs, Tokico Front and Rear shocks/struts
Add: Front Adjustable Street Camber Plates $139 pair
240Z-280Z Street suspension kit:
Urethane bushing kit, Front 1.125” sway bar with urethane bushings, Rear 7/8” sway bar with urethane bushings, Street lowering coils, Tokico Front and Rear Strut Inserts.
BMW Specials: Click Link to to to our Main BMW Performance Page
|
Super Deal Limited Time Limited Quantity Offers.
|
|
|
SALES SPECIAL |
|
NEW PRODUCT
BMW M10 Shorty Header for 2002, E21 and E30 Cars.
Click for more info, pricing, etc.
NEW Product:
E12 Rear Shock Tower Brace and Battery Relocation kit
E12 Front Strut Tower Brace
E12 Front and Rear Strut Brace and Shock Tower Brace Combo
320i Front and Rear brace package
2002 and 320i 1.5" Header
+ Add $20 for 02 sensor bung
+Add $18 for Heat Shield Exhaust Manifold Gasket
BMW 325 E30 Headers
BMW 325, 325 I / IS, shorty set to cat. converter. These are VERY nice headers
Front Urethane bushing kit for 2002
Rear urethane bushing kit for 2002 and E21
2002 Front End Steering Rebuild Kit
Center Drag Link, Complete Left and RIght Steering Rod Assemblies, Ball Joints, Idler Arm Bushings
2002 Big Front Brake Kit
10.2" Vented rotors, 4 Piston Girling Brake Calipers, Metal Master brake pads, Front hubs with Wheel bearings and seals, Dust caps and wheel studs...Bearing races already installed in hubs. This is an awesome kit for any street or track car...Works excellent with stock rear drum brakes,...In fact that is what we recommend for all street use.
2002 Front and Rear Brake Rebuild Package:
(2) New Brake Rotors, (1) Set of 4 Metal Master Pads, (2) new Rear Brake Drums, (1) set of 4 Rear Brake Shoes
320i Front and Rear Brake Rebuil Kit:
(2) New Brake Rotors, (1) Set of 4 Metal Master Pads, (2) new Rear Brake Drums, (1) set of 4 Rear Brake Shoes
2002 Performance Braking Package:
2002 Big Front Brake Kit with (2) new Rear Brake Drums, (1) set of 4 Rear Brake Shoes, Set of (4) Steel Braided Brake lines
215mm H/D Street clutch for 2002 or 320i
2002 Oil Pan Baffle
Steel Braided Brake lines (set of 6.)
Tii Air Filter pipe with K&N filter $159 (battery must be in trunk to use...)
320i Rear brace pacakge and air filter pipe kit
Tii rear brace package and air filter pipe kit
Tune up special
Pertronix electronic ignition conversion, 8mm wire set, NGK plugs, Cap and Rotor
E21 320i Front Heavy Duty control arms with ball joints and
euro rubber bushings each side
|
4 cylinder M10 SHORT BLOCK Performance Engine Rebuild kit: (2002,320i, 318i) JE Forged pistons (Any bore size or compression ratio)with JE Pro-Seal Rings German Rod and Main bearings (std, 10, 20) Full engine gasket set Timing chain, tensioner and guide rails
|
|
4 cylinder M10 LONG BLOCK Performance Engine Rebuild kit: (2002,320i, 318i) Performance Dual Valve Spring set New Rocker arms and Rocker Shafts New Heavy Duty Cylinder Head bolts JE Forged pistons (Any bore size or compression ratio)with JE Pro Seal Rings German Rod and Main bearings (std, 10, 20) Full engine gasket set Timing chain, tensioner and guide rails Oil Pumps have been discontinued and are very difficult and expensive to find....IF we have any available the average cost for the pumps will be $549 + Add $120 for Total-Seal Gapless 2nd Rings + Add $152 for Gapless Top Rings + Add $129 For Rod bolts and Nut Set + Add $149 for ARP Head Stud Set + Add $89 for ARP Main Stud Set + Add $141 for Cometic MLS Head Gasket in .051" thickness |
|
JE Forged piston sets with Wrist pins and JE rings 4 cylinder (Including S14)
+ Add $100.00 for Total-Seal Gapless 2nd Rings
6 cylinder (Including S50, S52, M3, M5) + Add $150.00 for Total-Seal Gapless2nd Rings
|
Special Deal on the Dual 40 or 45 DCOE DCOE Sidedraft kit.
2 New Weber 40 DCOE Carbs, Intake Manifold and Linkage Kit
For 40's
For 45's
Toyota Specials: Click to go to our Main Toyota Performance Page
JE Forged Piston Set.. .020 over 8.5:1 with JE Piston RIngs
Pauter OR Carillo Forged Connecting Rod Set for 3SGTE set of 4
|
3SGTE Performance Street Engine Rebuild Kit
|
|
7MGTE Performance Engine Rebuild Kit |