the #1 source in the world for 2.6 Performance engine, components and accessories....
(818)764-1901.........(818)764-0155 fax.........e-mail: topend@racetep.com
Monday through Friday 8:00am - 5:00pm Pacific Time
7452 Varna Ave. North Hollywood CA 91605
 Secure Server Online Ordering    
Current Sales Specials
NEW Turbocharger installation Do's and Don'ts...Read This !

Turbochargers, Intercoolers, Boost Controls, Compressor Bypass valves:

We offer a variety of Turbo upgrades for the StarQuest. We always get asked…”What is the best Turbo to go with ?” That answer depends on what you want out of the car when you are done. Here are the Turbo upgrades we offer and their features. Be sure and be honest about what you want from the car when making the Turbo choice and you will not be disappointed. The Turbos listed here will perform as stated so if you really know what you want from the car you will be happy. We do not rebuild Stock Starion Turbos. It is a waste of time and the failure rate is too high. It is a fine thing to do to sell the car or just to patch it up for a short time, but it will fail again. Any time a Turbo is replaced you need to replace the oil feed line with it. We offer stock replacement oil lines ($22.95) as well as Steel Braided lines which are cleanable and re-usable. They also flow more oil than the stock unit for longer life. ($50.00)

We no longer do upgrades or rebuilding to existing Mitsubishi Turbos…The cores are very rarely

good and failure rate is very high…We only supply NEW turbos….

NOTE: 2-1-2010
Everyone with one of these cars knows it has become very difficult to get new Bolt-On Turbocharges these days. Rebuilding stock units is a terrible idea and rarely works out well. The proper parts are just not available to rebuild these old stock units properly which just results in a total waste of money...To address this we have come with a great cost effective option for putting a new High Quality Performance Turbo on your stock or modified Starion / Conquest.

We are not going to use any of the Cheap Chinese Knock Off Turbos that have no Warranty. These are new Garrett or Turbonetics units with full Warranties and everyting needed to bolt them on...

New 14G Sport Turbo   CALLor email  
This is the Turbo to use to replace your dead stock unit or if you want a fun street car that will never make more than about 250 HP. Requires no modifications to system and will not hurt your stock engine. This is a New Turbo, not a rebuilt so no core is needed. Complete with Wastegate and Actuator. Just bolt it on. $895
Limited availability

See our New T3 and T3/T4 Page:

14G Sport Turbo Package..New 14G, Downpipe with 1 wire 02, Manual boost control
CALLor email

   

New 16G Super Sport Turbo CALLor email

A tried and true upgrade. Much more aggressive than the 14G. A good 300 HP Turbo. Does not have quite the high RPM capability of the Super-16G upgrade but still a good choice for an Aggressive street car or 13 sec ¼ mile car….  

See our New T3 and T3/T4 Page:

16G Super Sport Turbo Package..New 16G, Downpipe with 1 wire 02, Manual boost control
CALLor email

   

New Super 16G Turbo   CALLor email

Similar to the 16G but with the larger factory race wheel…Killer turbo up to 350HP and it bolts to the stock exhaust manifold….The best bolt-on STREET Turbo you can buy for your Starion or Conquest…  

See our New T3 and T3/T4 Page:

Super 16G Super Sport Turbo Package..New 16G, Downpipe with 1 wire 02, High Performance Manual boost control
CALLor email

   

New 19C Race Turbo CALLor email

See our New T3 and T3/T4 Page:

The absoloute maximum Bolt-On Turbo for the Starion and Conquest...Bolts to stock manifold and uses all same downpipes, oil lines, etc that you already own...550+ CFM at 15 psi boost and 380+ HP capable. 15 degree turbine clip is standard on this unit....This is an awesome turbo that alot of development time has gone into...For a street and strip car into the 12 sec range without the extra expense and hassle of the T3/T4 conversion this is the answer for you....  

19C Race Turbo Package...New 19C, Downpipe with 3 wire 02, HIGH PERFORMANCE Manual Boost controller
CALLor email

See our New T3 and T3/T4 Page:

     


Shown with optional External Wastegate and High Heat Coatings.

T3/T4 Hybrid Turbo conversion package                                                        
with Internal Swingvalve Wastegate (Applications to 400HP)

          The Ultimate Turbo for the Starion/Conquest. Nothing else compares. Fast spool. Amazing RPM capability. You thought your Starion engine did not rev up because it is a long stroke truck engine. It is really because the tiny Turbo on it runs out of steam at 5000 rpm. Bolt a T3/T4 system onto your stock 88-89 and what the engine scream to 7000 still making power. Of course you should have a good engine before doing this. Once it is uncorked and running freely the 2.6T is fully capable of 7500 RPM. That is how you get the good ¼ mile times. With the standard rear end gear ratios you need to be able to rev to at least 7000 RPM in the first 3 gears to run in the mid 13’s or better.

Turbocharger with internal wastegate assembly. New exhaust manifold
Downpipe with 02 sensor. Inlet pipe from Turbo to Mass Air Sensor.
S/S Oil feed line. Water line kit. Oil drainback pipe. All needed hardware and gaskets.

Options to T3/T4 kit:
Ceramic Ball Bearings $350.00
Ported internal wastegate for higher flow $150
2400 degree High heat coating on exhaust manifold and Turbine housing $250


T3/T4 Hybrid Turbo conversion package                                                         $2795.00
with EXTERNAL Wastegate
(350-500+ HP Race applications)

Same kit as above but the Exhaust manifold is different and the internal wastegate is replaced with a TurboSmart 38mm unit...Not meant for street use but for all out drag race and endurance road race applications...

Options to T3/T4 kit:
Ceramic Ball Bearings $350
2400 degree High heat coating on exhaust manifold and Turbine housing $250



Stock and performance Turbo Components and Upgrades:

Stock Replacment Oil Feed Line                                                                                           $21.95


Steel Braided High Flow Oil Feed Line                                                                            $60.00

Turbo Metal Water Line set with washer and hose                                                               $79.00

Stock or 14G Turbo rebuild kit (Starion and Eclipse.)                                                          $169.00

Exhaust manifold studs and nuts only                                                                                    $22.00

Turbo to manifold stud and nut set                                                                                       $29.00

Turbo to Downpipe stud and nut set                                                                                    $22.00

           

Wastegate upgrade                                                                                                            $150.00

Dual port Wastegate actuator for stock, Super-60, or 16G turbo upgrade. Very precise control. Up to 14psi baseline boost without VBC. Bolt-On replacement for stock unit. Comes with mounting bracket. Same actuator we use on the T3/T4 kit.

Ceramic Ball Bearing upgrade for T3/T4 Turbo Package                            $500                                      

          The Ultimate in long life and fast spool up. Nothing else like it.

Click links below for Turbo info and pricing
T3/T4 Turbo Only
                                                                                             

Ceramic Ball Bearing upgrade for T3/T4 Turbo only                                            

T3/T4 Turbo with internal wastegate and actuator standard bearing                     

T3/T4 Turbo with internal wastegate and actuator ceramic ball bearing   
Click links above for Turbo info and pricing              

External Wastegate Cast iron T3 exhaust manifold only                                                    $495.00

Turbonetics Evolution Wastegate                                                                                        $259.00

The all around best and most affordable SMALL external wastegate available. Comes with flanges and gaskets

Turbonetics Deltagate Racegate                                                                                         $416.00

            The Best and Most affordable BIG Wastegate available. Comes with flanges and gaskets

NEW Turbocharger installation Do's and Don'ts...Read This !



 error-file:tidyout.log

All contents on these pages © 2004-2005 by Top-End Performance and Steve Nelson. No portion of these pages may be reproduced or re-published in any form without the express permission of Steve Nelson and Top-End Performance. This does not include links to other pages and downloads for personal use. We encourage that. In other words... Don't bag the pictures and text and put them on a site or in a sales or service catalog or otherwise pretend that they are your own.



This DSM Webringsite owned by Steve Nelson and Top-End Performance.
[ Previous 5 Sites | Previous | Next | Next 5 Sites | Random Site | List Sites ]


Top-End Performance
7452 Varna Ave
N.Hollywood CA 91605
(818)764-1901   (818)764-0155 fax
e-mail: topend@racetep.com
To Top-End Performance Main Page